10M MC Sewage Float Switch

Excl. Tax £42.00 Incl. Tax £50.40
In stock
SKU
10MCFS

The MC Float switch can be used to operate submersible pumps via a control panel. Ideal for sewage pump applications. The switch will give a open or closed contact.

 

Please see below for functions and technical data

  • Buy 10 for Excl. Tax £35.50 £42.60 each and save 16%
  • Buy 25 for Excl. Tax £33.50 £40.20 each and save 21%
  • Buy 50 for Excl. Tax £31.60 £37.92 each and save 25%

Submersible float switch for sewage pump applications. Multi contact connection to give normally open or closed contacts. 10m 3 core cable

 

Technical Features

  • 20A resistive load - 8A motor load
    (max absorption with 20m of cable: 10A)
  • Wire guage: 8.8mm
  • Operating temp:
    with H07 RNF cable: -15°C to +60°C
    with VVF A07 cable: +5°C to +60°C
  • Max depth: 40m
  • Protection grade: IP68 

Terminal Connections

 

Please follow the figures of the terminal connections 

The upstream circuit must protect the electric wires from the overcurrent. WARNING: lack of protection shall null and void the warranty in the event the float breaks.

  • Mod.01: single function - only emptying of only filling (fig.1). The grounding wire is always yellow and green
  • Mod.02: double function (choice of the fitter installing)
    Emptying: (fig.2) use black and brown wires. Note: the blue/grey wire must be insulated.
    Filling: (fig.3) use black and blue/grey wires. Note: the brown wire must be insulated.
    High Level Alarm: (fig.2) use black and brown wires. Note: the blue/grey wire must be insulated.
    Low Level Alarm: (fig.3) use black and blue/grey wires. Note: the brown wire must be insulated. 

Unlike normal floats, the level regulator is used in pairs of two of the same type to regulate water levels to a certain height: one regulates the minimum level and the other regulates the maximum. A third and fourth can also be used for min. and max. alarm respectively. To avoid damaging the cable, we recommend using a fixing kit (fig.4).

 

NOTES: DO NOT TAMPER THE FLOAT SWITCH

  • Before any operation on the float, remember to disconnect the power supply from the main power
  • Check that the max. motor power does not exceed the float's electrical values
  • The electrical cable is part of the floating, thus in case of cable damage, the float itself has to be replaced.
  • No joints should be made on the float switch cable, as immersion joints could cause short circuits of electrical shocks.
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account